XE1205
7.3
OPERATING MODES
The XE1205 has four main operating modes illustrated in Table 26 below. These modes are defined by register
MCParam_Chip_mode(1:0) when bit MCParam_Select_mode is low and defined by SW(1:0) pins when
MCParam_Select_mode is high. Please note that in both cases the changes will be applied to the transceiver upon the
rising edge of the NSS_CONFIG signal (ie NSS_CONFIG must be set low even when using SW(1:0) as inputs).
MCParam_Select_mode
0
0
0
0
1
1
1
1
MCParam_Chip_mode(1:0)
00
01
10
11
00
01
10
11
SW(1:0)
mode
Output
Output
Output
Output
Input
Input
Input
Input
SW(1:0)
value
00
01
10
11
00
01
10
11
Operating
Mode
Sleep
Receive
Transmit
Standby
Sleep
Receive
Transmit
Standby
Enabled blocks of the
transceiver
-
Quartz oscillator, Frequency
synthesizer, Receiver
Quartz oscillator, Frequency
synthesizer, Transmitter
Quartz oscillator
-
Quartz oscillator, Frequency
synthesizer, Receiver
Quartz oscillator, Frequency
synthesizer, Transmitter
Quartz oscillator
Table 26: Operating modes
7.3.1
XE1205 switching time using SPI_CONFIG interface.
The transceiver is able to switch between modes by using the SPI_CONFIG interface.(MCParam_Chip_mode(1:0)) or by
using the pin SW(1:0). This section describes the switching sequence of the transceiver when register
MCParam_Select_mode is low i.e. the configuration is done via the SPI_CONFIG and SW(1:0) is an output.
The sequence from sleep mode to receive mode via stand-by mode is shown in Figure 19 Error! Reference source not
found. TS_SRE is the receiver wake-up time when the oscillator is enabled, defined as the initialization time for the
frequency synthesizer and the base band filter. The base band filter initialization and calibration processes occur when
the transceiver switches from stand-by to receive.
Programmed mode
Sleep
Stand-by
Receive
NSS_CONFIG
Actual mode
Sleep
TS_OS
Stand-by
Receive
TS_SRE
Figure 19 Sequence from sleep mode to receive mode via standby mode.
The sequence from sleep to transmit mode via stand-by mode is displayed in Figure 20. TS_STR is the initialization
time of the frequency synthesizer and the power amplifier.
? Semtech 2008
36
www.semtech.com
相关PDF资料
XE1283I076TRLF IC TXRX UHF LOW POWER 72-LFBGA
XE135B LAMP GAS T3.25 XENON 13.5V .375A
XE193 LAMP GAS T-3.25 XENON 14V .33A
XE2405 LAMP GAS FILLED BI-PIN 24V 5W
XE2410 LAMP GAS FILLED BI-PIN 24V 10W
XEB09-BIS MODEM ETHERNT BRDGE MPT OUTDOOR
XK-Z11-S ZIGBEE MODULE DEVELOPMENT KIT
XOB17-12X1-TR SENSOR MONOCRYSTALLINE MODULE
相关代理商/技术参数
XE1205SKC915XE1 功能描述:KIT STARTER FOR XE1205 915MHZ RoHS:否 类别:RF/IF 和 RFID >> RF 评估和开发套件,板 系列:TrueRF™ 标准包装:1 系列:- 类型:GPS 接收器 频率:1575MHz 适用于相关产品:- 已供物品:模块 其它名称:SER3796
XE1209 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:Ultra Low Power CMOS Transceiver
XE1209C012TRLF 制造商:Semtech Corporation 功能描述:
XE1209C061TRLF 制造商:Semtech Corporation 功能描述:
XE1212 制造商:未知厂家 制造商全称:未知厂家 功能描述:MODEM
XE1212BL5 制造商:未知厂家 制造商全称:未知厂家 功能描述:Telecommunication IC
XE1212E 制造商:未知厂家 制造商全称:未知厂家 功能描述:MODEM
XE1212L 制造商:未知厂家 制造商全称:未知厂家 功能描述:MODEM